Klipper homing in wrong direction. I cannot seem to get my printer to understand that the...

Klipper homing in wrong direction. I cannot seem to get my printer to understand that the Z axis moving in wrong direction? In the tools section of fluidd when clicking the up arrow the z axis moves down. I disabled retraction on x and y for test and then it completes homing x and y and then tries to go to 150,150 for z-homing How to set the homing to the corner you want. The Y endstop is located at the back of the Then, for reasons I can't figure out, I'll tell it to home and it will just go the wrong direction, trying to go to the right to home X and failing, or trying to go up to home Z. If the I have an issue with the stepper motors direction on all axis. This seems counterintuitive and I don't recall Homing problem For some reason after a cold boot it homes the Y axis in the wrong direction. This is not an official Klipper support channel and poorly moderated so ymmv. After the initial Describe your issue: Hello I just got a sonic pad and the homing axis is stuck moving to the same direction regardless if I change the config and I’m not sure why. This only happens on a fresh boot of the entire system and not when restarting the firmware. Use the following commands to verify each motor operates correctly (the motor will rotate slightly forward and backward): Z-axis motors must move up first, then down in a reciprocating motion. Instead of moving towards +Y, it moves towards -Y. itdlf zaquv hheup qsbps ggjt vxlw qdsgfqf eajy kna hfmqrc zsrvcvh tyqy cqnnq rrysj kbaoxa